How to refinish a table top

How to finish a table top? If you do a sloppy job here the rest of the project will suffer, But if you. The most important step.

First off, the good news is that you may not have to purchase the tool to sand. Take a good look at the table. Note the color, finish and anything else that you notice.

What is wrong with the table top? I have a chinese made oak. If using an orbital or belt sander, be careful not to. Carefully remove all sanding dust with a tack cloth.

Give the stripper time to do its job, then scrape and sand carefully to bring the natural wood surface back to life. To do this, you need to remove all traces of the previous stain and smooth out the damaged surface with a sander. Start with grit sandpaper in a random orbit sander. Go slow so you don’t leave whirls on the surface.

I only did the top , just to get a little more life out of it. Use a clean rag to apply Minwax pre-stain conditioner to the table top. Wipe off any excess conditioner and allow to dry for around minutes. With a clean rag, apply the stain. Wipe the surface of the entire table using the tack cloth.

Brush the stain liberally onto the. Begin by removing your wooden tabletop’s old surface, whether it’s made of wax,. Next, attach some heavy-grit sandpaper to a sanding machine. Step – Smoothing. Then, sand the tabletop.

A typical varnish and stain removal method is sanding. However, we didn't want to sand the varnish off of this table because. Apply the Stripper. Cover It All With Plastic.

Wait Until the Varnish Separates. Scrap Away the Finish. Reapply the Stripper as Needed. Don’t stop until you achieve perfection. Smooth shaped edges with synthetic steel wool.

Move the table to a well-ventilated area. This work can be done in a workshop,. After stripping the finish from a table or other piece of furniture, sand it smooth and clean it with mineral. When the mineral spirits dries, begin staining the furniture. Use fine-grade steel wool to brush the stain into.

Buff the stain from the. Sand the entire table to remove all stain from edges and legs. Work slowly to avoid gouging the wood.

Use steel wool to scrub the finish off in areas that are hard to reach. When you go to stain they will will become more noticeable. Doing this last step of hand sanding will make all the difference in your finished project. If you’ll only seal the bare woo don’t apply stain. Put on chemical-resistant gloves and dip a rag into the.

Free 2-day Shipping On Millions of Items.