How to polish truoil

Finishing Schedule For Tru-Oil Prep the guitar or wooden project by sanding to 2grit and removing all scratches. Wipe the piece down with a clean. Apply the first coat on the surface very thinly and evenly.

Allow the coat to dry completely and apply another coat just as thinly as the first. How to polish a True Oil finish on a guitar. Witness lines during the Tru-Oil process of leveling and. VERY vigoursly WITH the grain, with a clean 4count sheet (balled up) damped with a VERY small amount of orange or lemon oil. Best product for polishing a tru oil finish.

BIGDGUITARS 34views. Steaming dents out of a gunstock and stripping. You can absolutely buff Tru Oil if you want. Tru-oil , allowed to dry properly (a couple weeks minimum, longer is better), can be wet-sanded and polished to a very high gloss.

A short video on how I achieve a high gloss using Tru- Oil. Tru-Oil has a relatively soft surface, similar to polyurethane, and trying to shine it up with compounds is going to yield a sorta matte finish. The Tru - oil finish was done over a tobacco burst die finish. Bay Is Here For You with Money Back Guarantee and Easy Return.

Tru-Oil Gun Stock Finish has been the professional’s choice for easy, top-quality gun stock nishing for more than years. Read Carmichel’s Tip on. Starting with 4grit sandpaper.

Use a piece of felt moistened with mineral oil (a.k.a. baby oil ). This is basically a very fine abrasive which, in my experience, works better than extra fine steel wool. A Tru-Oil finish is weather resistant (this is the term Birchwood Casey uses, not “proof”), looks terrific, is very tough, and can be easily repaired or renewed. The method of putting on a fair bit of tru oil and sanding while wet is to get the wood dust to mix with the tru oil to fill the pores. If you have already sealed it with a sealer and pore filler there is no point wet sanding. And yes for a body I would build up probably a lot more than thin coats.

There are lots of ways to apply Tru Oil and everyone will find a way that works for them. I go about my Tru Oil finishes a little different. I use a combination of using a lint free patch of cloth to wipe it on when building the film and then spray the last couple coats. Only buy the small bottles because of the short shelf life.

Sand the wood to 2making sure theres no deeper scratches left in that shows later. Wet sand with tru oil and 2until it makes a filler slurry that fills the pores. Don’t rub it in, just let the wood absorb it. Sand with the grain, and let the Tru Oil cure about a week before you polish. I actually used to use tru-oil , but recently switched to tung oil.

The blending result is hit or miss though. I removed Tru-oil from a neck using denatured alcohol. Just soaked a rag in it and scrubbed it off a little at a time. This probably fills the pores faster and more reliably than just coat after coat of tru - oil by itself. Then, sand the Tru-Oiled surface with 4grit sandpaper, using more Tru-Oil as a sort of lubricant, and using circular motions over a small section at a time.

This “slurry” of Tru-Oil and sawdust will fill in the grain and seal itself as it dries. Looking For Tru - oil ? We Have Almost Everything On eBay. Fast and Free Shipping On Many Items You Love On eBay.