Ground rod installation

Using your hammer, drill, or driving tool, gradually drive the rod vertically into the ground. You need to drive your rod all the way into the ground. To save yourself from having to dig a deep hole to install the rod in, you can opt to use water instead.

Start by digging a small hole where you plan to place the pole, and add water into it. This will make the ground softer and easier to work with, so you can simply stick the ground rod in and start pushing your way down, an inch or two at a time. You shouldn’t have any problem with this unless you encounter a rock. When installing ground rods , always ensure that at least 8’ of the rod is in direct contact with the soil and that the rod is embedded a good distance below the permanent moisture level of the soil.

In this case we are adding a ground rod to the my new Vertical Antenna system. Add some water to the hole and start plunging the rod into the dirt about one inch deeper per plunge. Don’t go too far or you will have difficulty pulling the ground rod out. In less than minutes, you can have it installed and buried even if you are dealing. How do you install ground rod?

Check out my new video about how to repair a water heater dip tube. How far should a ground rod be from the House? This is necessary when your hot water gets cold. Unsubscribe from Dual Homestead? Ground Rod Installation Using ERICO Ground Rod Driver - Duration: 1:41.

G) Rod and Pipe Electrodes. It shall be driven to a depth of not less than 2. The electrode shall be in-stalled such that at least 2. The only legal ground rod must be installed a minimum of 8-foot in the ground. The length of rod and pipe electrodes is located at 250. See figures and for the section requirements.

However, what if I were to tell you this statement is not entirely true? Order by 10pm for Same-Day Shipping. Wide Selection of P rod ucts In Stock at Allied.

Carry on plunging the ground rod into the hole and when the protruding piece is short enough, tap it with the hammer until it has reached the depth you desire. As you can see, ground rod installation is a very simple process when you have clear and easy instructions to follow. Additional Resources. Installation Process Now place the rod in the hole again, and using the rubber mallet, strike it to enter deeper into the ground.

Keep repeating this process until it reaches the required depth. Once that is accomplishe strike the rod into the ground for the final time, but do not add water into. How to Install a Residential Grounding Electrode 1. Most ground rods are copper cla not solid copper, it just depends which one you purchase. If ground rod cannot be driven in feet because of bedrock, call Digi-Star for additional grounding instructions. Kugellagers Noodle 60views.

Its primary function is to create a path to ground for electrical current, such as lightning, line surges, and unintentional contact with high voltage lines. I want to emphasize the importance of matching the appropriate ground rod to the application. If the facility being grounded has a life expectancy of less than years, a galvanized ground rod is appropriate and will provide the most cost-effective solution.

For installations with a longer service life, copper-bonded ground rods are the best fit.