How to install stair treads over existing stairs

You either get stair treads or large pieces of the desired wood. Then find out if all of the stairs are the same size or different sizes. If they are all the same size then you will just need to. Unfortunately, your other friend is correct.

The stairs pose a tripping liability. Your fix is to rebuild the stairs yourself or have a professional complete the task. How to update your staircase? How do you install hardwood on stairs?

How wide should stair treads be? What goes first the tread or the riser? After removing the old carpeting, vinyl or other floor covering, the first step is to eliminate any bull nose on the exposed lumber tread. One way is to cut it off. Using a handheld circular saw or jigsaw, cut the bull nose of the tread back flush with (or slightly behind) the existing riser.

Loosen the screws on top of the stair gauge so that you can extend the wings fully against the skirtboard. Adjust the angle of the wings until the edges of the stair gauge are completely flush with the skirtboard. Tighten the screws to hold the measurement in place.

Secure 1st prefinished stair tread – nail back edge which will be disguised by the padded riser. Install the 1st riser with the cut edge up and the factory edge against the stair tread. Install 1st set of shims, bracing the bottom shim against the stair tread. Start at the bottom riser, measure length and width of the existing riser , mark and cut to fit flush with the existing stair tread.

Glue and nail the riser in place. Free Estimates From Pre-Screened Stair Install ation Contractors. Free 2-day Shipping On Millions of Items. Using a screwdriver or your power drill equipped with a screwdriver bit, screw your stair treads down into the stair. Take extra care when screwing so as not to snap your mounting hardware.

Underneath each trea on both ends where the tread fits into the stringers, a wooden wedge is driven to tighten the tread and hold it in place. This wedge is far superior to simply nailing or screwing the tread down to the stringers. Nail or screw a piece of 1-by-4-inch pine along one edge of the plank as a backstop when cutting the treads. If unfinished oak is planned for the risers, remove and replace. Measure and cut to fit.

Repeat the same process with the PL glue and place down securely. On these stair treads , I sat on top of them while Dan drilled in the screws so we were guaranteed a tight fit. I wanted them to hang over about an inch and that is how we finished them. They go right over the old step treads , the horizontal board that you walk on. Some covers also conceal the old step risers , the vertical boards between the treads.

That’s when I discovered pre-cut stair treads and risers in unfinished pine and oak at my local home improvement store. I started wondering if we could just add new treads and risers over the old. Installing Hardwood Stairs with side stringer veneer.

I am scheduled to rip out existing , carpeted stair treads and install new, oak treads. The existing stringers will remain in place. I plan on pre-drilling the treads and anchoring them using long, cabinet (small head) screws.

My question deals with eliminating squeeks. Never nail into a block from either a tread or a riser. Adhere the blocking to the risers and the stringers using a construction adhesive. Use a dimensional sized 2-by-piece of lumber for blocking material.

The top tread on the stairs that cannot be accessed from underneath cannot be glue-blocked. Use generous amounts of adhesive to account for the lack of glue blocks.