How to install drawer slides step by step? Where to mount drawer slides? How much space do you need for drawer slides? How do you replace cabinet drawer slides?
The slide should fit flush and behind the drawer front. Use the oval-shaped screw holes (one in front and one in back). Center the screw in the oval-shaped hole.
Rather than me re-inventing how to do the job here, I would suggest you do a search for a video to show you exactly how to do it. This web site might be helpful, I think so. Just last weekend I knocked together some dovetailed boxes and installed my first set of runners which demystified the process a great deal - but also raised some. And I’ve installed thousands of them. What makes installing slides so difficult?
For center mount slides , use per drawer. Then marking holes and mounting the other section of the slide to the sides of the drawer. So to start, you’ll swap the direction of the Kreg jigs, and clamp them in place pressed firmly against the bottom of the drawer slide. Begin by attaching the drawer-mount member. With the slide aligned flush to the drawer front and bottom edge, attach with a screw at the front in a vertical slot, photo below, and then add one at the rear.
Get Blum Undermount Drawer Glides. Free 2-day Shipping On Millions of Items. Buy Top Products On eBay. Money Back Guarantee! Find Great Deals Now!
Measure to where you want the bottom of the drawer to sit and clamp a support board in place. Make sure the support is level from the front to the back. If necessary, add blocks to the slide.
Empty desired drawer and remove it from the cabinet. Unscrew the existing drawer. Place the drawer on its side. Align the glide flush with the bottom of the drawer , being. Because the right slide is the “guide slide ” if you install that slide correctly your time can be cut.
As the left slide is merely a track it can be positioned with the drawer installed. With years of experience I’ve been able to install epoxy slides in just a few minutes. Before starting any installation project, make sure you have all the necessary tools to install your slides. Use a pencil to mark the place. Full-extension range allows the drawer to open fully for best access to contents in the back.
Less-costly, ⁄ extensions open to expose all but the back fourth of the drawer. Lubricated bearings make for the smoothest sliding action. Typical ball-bearing slides sell for about $to $per pair. Installation is the same for each style. Using a single slide ($to $per pair) in the center of the drawer reduces hardware costs.
Locate the centerline on the drawer bottom and make marks to the left and right of the line at the front and back of the drawer.
No comments:
Post a Comment
Note: only a member of this blog may post a comment.