How to stain butcher block

Explore our Preparation Products Now. Free 2-day Shipping On Millions of Items. Or if the block is small enough, try soaking in dish soap with a bit of bleach overnight. You might not be able to get it out because whatever it is may have seeped into the wood.

If all fails, ask your local hardware store for. Two options to try. Make a paste of oxi-clean and apply it to the spot. This worked for me after a bottle of ink spilled in a dresser drawer.

Another option is Bar-Keepers Friend scouring powder. It has oxalic acid in it which acts as a. What is the best butcher block? Choose a water- or oil-based wood stain in the color you prefer. Oil-based stains are longer lasting and more stain. Test the stain on a small section of the butcher block.

Use a fresh inches ( cm) paintbrush to apply a single. Let the stain dry for hours and. It is advisable to stain in long strokes in the direction of the wooden slats. Let The Stain Dry : Leave the stain to dry for at least hours, the stain must be fully dry before applying a second layer.

Avoid setting any of the objects on the wet stain during drying time. STEP ONE – apply a wood conditioner appropriate to the stain you’re using. If you’re using an oil-based stain , use a wood conditioner meant for oil-based stains.

I was using a water-based stain so used this wood conditioner. Stains with suspension agents are based with water, alcohol or petroleum distillate. Lacquer, polyurethane and varnish coat the wood rather than soak into it.

These stains are easier to. Let sit for at least hours or according to the brands instructions Sand down lightly with 220-grit sandpaper and wipe surface off again with a clean rag. Apply your stain to the surface.

Wipe the butcher block with a damp, soapy wash cloth to remove sanding dust and dry thoroughly. You must treat the exposed surfaces with a food safe mineral oil to protect and moisturize the wood. The best cure is to apply Boos Mystery Oil to penetrate the cutting board and restore the moisture.

The Shop Vac will catch most of the dust. After everything was sanded down, and the dust was wiped away, I put a coat of Wood Conditioner on the butcher block according to the instructions on the can. I used Minwax, and found it at Home Depot. Polyurethane is a liquid coating that dries into a plastic film and is excellent for sealing the countertop, but then there’s a layer of plastic between you and your pretty new wood. Begin by mixing half Pure Tung Oil with half Citrus Solvent – this ensures that the oil penetrates the wood.

I love the smell of the solvent, it’s like a room full of oranges and is the most lovely smell in all the land. If neede sand the butcher block surface for an even appearance. Stir a teaspoon of powdered oxygen bleach (sodium percarbonate) into a cup of hot water until it dissolves. Wearing a nitrile glove, dip a stiff, nylon-bristle scrub brush into the solution and scrub the wood for a couple of minutes.

Redip as needed to keep the surface wet. The mix will foam slightly, then subside. With products I had in my home and just a few minutes of work my butcher blocks was back to it’s original beauty. I did small sections at once (about a foot long).

How awesome is that! I wiped each section down after a few minutes (with the wood grain) with a cloth. There are a lot of options for products to treat butcher block , but one of the simplest and least expensive is mineral oil. And that’s what I went with for the first several months.

Hardwood Reflections Weathered Gray gel stain is designed specifically for butcher block or other interior wood products that require a very high-end finish for an area of heavy use. Gel stains are very thick and provide a striking color when cured. Brush, pa or roller on the gel stain but do not forget to wipe clean before the product dries.