Dry scrape popcorn ceiling

What is the best way to scrape a popcorn ceiling? How do you remove popcorn from a ceiling? Only give it a light misting—too much water could damage the drywall or loosen the joint tape. You only need a scraper of a maximum of inched wide for this job.

Floor scrapers with thin wide blades will not do for this job. With a floor scraper you can do all of your scraping from the ground on and average foot ceiling. Use a joint knife to gently scrape off the popcorn texture on the ceiling.

Make sure that you have dulled the joint knife so that it does not gouge your ceiling and cause you more problems in the future. The water should soften the texture enough that the popcorn pops off easily when you scrape it. Removing popcorn ceiling that way makes a big, sloppy mess and almost always leaves you with repairs to do afterward. With painted texture, some pros scrape as best they can and then ‘skim coat’ the entire ceiling with a thin layer of joint compound. Scraping dry texture is a dusty mess, and skim coating requires some practice.

Some people spray the area with a water bottle and scrape it off once it softens but this can be messy since it usually ends up on the floor. Aaron Rollins might have come up with the best hack ever to remove popcorn ceilings and it requires only a few supplies. He duct taped a wide putty knife to the end of a vacuum hose and the suction removes all of the particles after he scrapes them off. Learn why this is NOT a good idea. It’s very easy to remove a popcorn ceiling compared to dry walling over it.

Then use a drywall blade to scrape the wet stuff off. You will probably need to touch up the the joints with a coat of drywall mud and sand later. Depending on heat and humidity, you just have to keep checking it until you feel it’s right. Then with a wide scraper, scrape off the bumpy texture.

For this condo reno, we were going to be installing a knockdown finish, so it was totally fine for some of the texture to remain on the ceiling from the old texture… just the pokey bumps needed to go. Free 2-day Shipping On Millions of Items. I then drywall tape a. STEP 2: Wet the popcorn ceiling.

Fill a garden sprayer with lukewarm water and spray the entire ceiling. Give the water about minutes to soak in and soften the texture, and then test a small. It took a TON of hard work and elbow grease to get this ceiling scraped without messing up the drywall paper underneath the popcorn. I would say it took Grant about a week of working on this ceiling. This coating removes painted popcorn ceilings, textured drywall ceilings or textured drywall walls, multi-layered paint, and scoured wallpaper safely from drywall, woo metal, concrete and other surfaces.

Hold the scraper at a very low angle - almost parallel with the ceiling. Push firmly, but if it fights you, add more water. Water is your friend! First things first.

Before you get starte invest in some Asbestos and Lead test kits. Adding a new drywall layer also gives you the option of insulating directly over the old ceiling before adding the new drywall. If the house is old. When it comes off the ceiling , the damp popcorn texture will stick to anything it touches. Remember, the idea behind the wet scrape isn’t to douse the ceiling with a garden hose, but to lightly mist the popcorn material just enough to allow it to pull away from the ceiling and fall (rather than float) once it’s scraped.

Yes, but first have the popcorn tested for asbestos. You can also use a taping knife to get the similar. The hard part is looking up for an hour and also finessing the joint compound to look smooth. But, if you can ice a cake, you can do this!

The Best Tool To Remove Popcorn Ceiling : POPEEZE. One of the more updated tools to use in removing popcorn ceiling is a product called Popeeze Popcorn Ceiling Scraper that has a vacuum attachment tool. It is basically a tool that removes ceiling texture without any bag or any mess at all. Starting from one end of the room, scrape the popcorn texture off the ceiling with the resurfacing tool while wearing a face mask.

This item consists of a sharp razor with a bag attached to catch. One solution to your popcorn ceiling situation is to cover it with drywall. Add Wood Panels or Beadboard. Looking for something more unique?

Wood paneling or beadboard gives your ceiling a fresh,. Popcorn texture is literalyl nothing more than gypsum chaulk. The residue left after scraping will normally just sand off or might even come off with a dampened block sponge. In the process of scraping, you will probably knick the drywall a bit.

Also, the seams may need a little topping off and then be sanded smooth with a drywall sanding block. Re: Scraping Painted Popcorn.